Installation Guide

Decking End Cap Installation:
1. Brush of debris from end of the deck board to ensure a clean  t.
2. Dry  t the end cap to make sure it will  t and trim tabs on back if required.
NOTE:
When applying to starter board, cut and remove the appropriate tab on the back of the end cap
with a razor or utility knife.
3. Apply a liberal amount of recommended glue to the end of the board. Follow clean-up instructions per
the adhesive manufacturer’s instructions for any excess glue.
4. Position the end cap so that the word “UP” and the arrows are oriented upward and the end tabs
line up with the grooves in the board. Apply adhesive per manufacturer’s instructions to ensure that a
good bond is formed between the deck board and the end cap.
Recommended Adhesives
:
• DAP - Rapid Fuse All-purpose Adhesive
• Gorilla Glue - Super Glue Impact Tough
• Loctite - Super glue Professional
Decking End Cap
PLEASE READ OWNER'S MANUAL COMPLETELY BEFORE INSTALLING
INSTALLATION INSTRUCTIONS
Adhesive
Utility knife
TOOLS/MATERIALS NEEDED:
BARRETTE OUTDOOR LIVING
7830 FREEWAY CIRCLE • MIDDLEBURG HEIGHTS, OHIO 44130
TEL: (
800) 336-2383
•
WWW.FREEDOMPRODUCT.COM
To obtain and review a copy of the warranty please go to: Freedomproduct.com/warranty.
You can also contact 1.888.418.4400 or write to Freedom Outdoor Living,
7830 Freeway Circle, Middleburg Heights, Ohio 44130 to obtain a copy of the warranty.
To register your product, please visit:
FreedomProduct.com