Instructions / Assembly

ADJUSTING THE DRIVE BELT

If the pedals slip while you are pedaling, even while the

resistance is adjusted to the highest setting, the drive

belt may need to be adjusted. Before you adjust the

drive belt, unplug the power adapter.

Remove the two Screw Caps (55) from the Shield

Cover (54). Next, remove the two indicated M5 x 12mm

Truss Screws (68). Then, remove the Shield Cover.

Next, locate the M8 Locknut (90) on the Eyebolt (8).

Tighten the Locknut until the Drive Belt (16) is tight.

When the drive belt is properly tightened, reattach the

parts that you removed.