Instructions / Assembly

6
1
1. Tip: Avoid pinching the wires inside the
Upright (2).
Raise the Upright (2) to the position shown.
Secure the Upright to the Frame (1) with
four M10 x 20mm Screws (111) and four
M10 x 16mm Washers (123); start all the
Screws, and then tighten them.
ASSEMBLY
1
2
111
123
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you fi nish all assembly steps.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see page 5.
• Assembly can be completed using the included
tools.
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.