Instructions / Assembly

8
5. Attach an Outer Pivot Cover (51) to the right
Inner Pivot Cover (50) with four M5 x 12mm
Screws (71); start all the Screws, and then
tighten them.
Then, press a Pivot Cover (52) into the Outer
Pivot Cover (51).
Repeat this step on the left side of the
elliptical.
4
80
93
36
26
34
94
2
5
71
71
51
52
50
4. Orient the Right Upper Body Leg (26) assembly
as shown.
Slide a Wave Washer (36) onto the right axle on
the Upright (2). Then, slide the Right Upper Body
Leg (26) onto the right axle.
Attach the Right Upper Body Leg (26) with an
M10 x 15mm Hex Screw (94), an M10 Split
Washer (80), and an M10 Washer (93).
Attach the Left Upper Body Leg (34)
assembly in the same way.