Installation Guide

INSTALL SUPPORT BRACKET
5
SECURE THE ACCORDION PANELS
 Page 8

Installation
Instructions
NOTE: Proper installation of this air conditioner
requires a downward slope to the outside of
3°to 4° for water drainage. If done correctly,
water should not drain from the overow
drain hole during normal use.
Fig.5A
Fig.7A
Fig.5B
Fig.7B
Fig.8
Fig.6
Fig.9
Fig.10
A.WIth the help of another person, carefully
place the unit into the window so that the
bottom of the air conditioner frame is against
the window sill (Fig.5A for wood frame windows
and Fig.5B for vinyl windows). Carefully close the
window into the top rail on the unit.
A: Drive 1/ 2" locking screws through the support
brackets, top channel, and accordion panel
frames and into the window frame (Fig.8).
NOTE: To prevent frame from splitting, drill
1/8" pilot holes before driving screws.
B. To eliminate the risk of the window being
raised while the air conditioner is still installed,
secure the right angle sash lock with 3/4” screw
as shown in Fig. 9.
C. Cut the window sash sealing foam and insert
into the space between the upper and lower
sashes, as shown in Fig. 10.
B.Extend the side panels out against the window
frame(Fig.6).
A.Select the appropriae frame lock and place
between the window sill and the accordion
panel frame as shown in Fig. 7A (for wooden
windows) and Fig. 7B (for vinyl windows).
Wooden Windows
INSIDE
OUTSIDE
H:About 3/4 to 1 （for 5 to 8K);
Measure from the cabinet edge
3
H:About 1 to 1 / （for 10 to12K);
8
H
Vinyl-Clad Windows
INSIDE
OUTSIDE
H:About 3/4 to 1 （for 5 to 8K);
Measure from the cabinet edge
3
H:About 1 to 1 / （for 10 to12K);
8
H
window
frame
4
INSTALL LOCKING SCREWS
6
FOAM SEAL