Installation Manual Ceiling Concealed Duct

OPTIONAL OPERATION
17
Installer Setting -Test Run Mode
After installing the product, you must run a Test Run mode.
For details related to this operation, refer to the product manual.
TEMP
FAN
SPEED
OPER
MODE
When pressing the button and
button simultaneously for more than 3
seconds, the system will be entered into
the installer setting mode.
- After entering into the installer setting
mode, select the test run mode code
value by pressing the button.
* Test run mode code value : 01
1
When pressing the button, the test
operation mode will be performed, and it is
displayed as shown in the left figure.
2
When pressing the button and
button simultaneously for more than 3
seconds after the setting has been
completed, the setting mode will be
released.
- If there isn’t any button input for more
than 25 seconds, the installer setting
mode will also be released.
3
When approx. 18 minutes are elapsed after
starting of the test oper-mode, the system
will be stopped automatically and converted
to the standby state.
- If any button is inputted during the test
run mode, the test run mode will be
forced to be relreased.
4
OPER
MODE
OPER
MODE
OPER
MODE
OPER
MODE
ENGLISH
• What is the test run mode??
- This means the operation of the product under the cooling, strong wind, and Comp on
state without performing room temperature control in order to confirm the installed state
during the product installation.
OPTIONAL OPERATION