Owner's Manual

6
CONTROLS AND SETTINGS
1
Wash Cycle Selections:
Favorite Cycle
The FAVORITE CYCLE option allows
you to program your preferred cycle
and options into one button. Once
saved, simply press the FAVORITE
CYCLE button to select the saved
cycle and options. Press the START
pad and close the dishwasher door
immediately to start the cycle.
To save a wash cycle to the
FAVORITE CYCLE button:
1. Select your wash cycle and
options.
2. Hold the MY FAVORITE CYCLE
button for 3 seconds.
The LED over the MY FAVORITE
pad will light up, indicating the
FAVORITE CYCLE option has
been saved. Repeat steps one and
two above to change the saved
FAVORITE CYCLE.
2
Wash Pressure
The programmed cycles default to
the “surge” pressure option which
varies the pressure optimally for
the cycle’s intended normal use.
If, for some special circumstance,
either a very low “spray” or very
high “scour” pressure is desired that
may be selected. Due to wash cycle
optimization, some pressure options
are not selectable in all wash cycles.
3
Wash Temp
The programmed cycles default to
the “normal” temperature option,
to choose HIGH TEMP or SANITIZE
press WASH TEMP pad.
CAUTION
Property Damage Hazard
Before starting dishwasher be sure that
the water is connected and turned on.
Failure to do so may cause damage
to the pump seal and result in water
leakage.
Wash Cycle Selections
Cycle times are approximate and will
vary with options selected. Hot water
is necessary to activate dishwasher
detergent and melt fatty food soils. An
automatic sensor will check the incoming
water temperature and, if it is not hot
enough, the cycle will be lengthened
for automatic water heating in the main
wash and final rinse of all cycles. This
happens even when HIGH TEMP WASH
option has not be selected. When HIGH
TEMP WASH is selected, an even higher
temperature will be reached to handle
heavier soil loads.
Option Selections

NOTE
Your dishwasher uses a DishSense
TM
Technology to understand how much
food is on the dishes and then adjusts
the cycle accordingly.
Recommended Cycle for typical
use:
The Normal cycle with its factory default
options of normal temperature and
heated dry together provide the best all
around performance. This cycle selection
is recommended for everyday use and
is suitable for a large range of both dish
load sizes and food quantities remaining
on those dishes.
2 3 4 5
6 7 8
2 3 4 5 6 7 81
1
9