Owner's Manual
9
OPERATING INSTRUCTIONS
Status Window
The STATUS window, available on some models, indicates the following activity:
*In all Error Code instances, if Pressing the cancel button or turning power o at the
breaker for 5 min. does not resolve the problem, contact the Frigidaire Customer
Care Center at 1-800-944-9044.
User Instruction Code
Error Code
1-24h Number of delay start
hours. The last hour will
count down in minutes.
CLOSE Close will scroll across the
status window indicating the
door needs to be closed.
MINUTES Number of minutes left in
cycle (1-199).
L0–L6. Level of Rinse Aid dosage.
Instruction
Code
Displayed
Problem/Condition Solution
Close This indicates the
door has been left
open or not properly
latched.
Ensuring the door is properly latched will
clear the display. This does not indicate a
problem with your dishwasher and service
will not need to be contacted.
PF Soft Power Failure: PF is displayed if a power outage occurs during
a wash cycle. The wash cycle will be paused temporarily and resume
once power is restored if the door has not been opened.
Hard Power Failure: A hard power failure means the unit will not
operate until power is restored. Pressing start within 18 hours of loss
of power will resume power at the point of cycle interruption.
Displayed
Error Code*
Problem Solution
i10 A low fill has been
detected.
Look for a pinched water supply line, or
water shuto is not completely opened.
i20; i40; iF0 Clogged filters or a
restricted drain line has
been detected.
Check and clean both filters and sump
area and check for a pinched or blocked
drain hose. If the drain line is attached
to a disposer, check that the knockout
plug has been removed.
i30 A leak or overflow of
water has been detected
in the bottom pan.
Look for loose connections at the
water inlet valve and ensure the unit is
properly leveled.
i50 A problem has been
detected with the drain or
wash motor
Pressing the cancel button or turning
power o at the breaker for 5 min.
should clear this error code and the unit
can be restarted.
If this does not resolve the problem,
service will need to be called.
i60 A problem has been
detected with the water
heating system.
iC0 A problem has been
detected with the
electronic control system.