FRI i i ]_I Location Operating www.
This USE & CARE MANUAL provides specific operating instructions for your model. Use the room air conditioner only as instructed in this USE & CARE MANUAL. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced when installing, operating, and maintaining any appliance. For Your Safety fire hazard or electric shock. Do not use an extension cord or an adaptor plug. Do not remove any prong from the power cord.
Selecting a Location Location IMPORTANT: 1.Dehumidifiermust be operatedinan enclosedarea to be most effective. Close alldoors, windows, and otheroutsideopeningsto the room. The effectiveness ofthe dehumidifier depends on the rate at which new moisture-laden air enters the room. 2. Place dehumidifier in a location that does not restrict airflow through the front of the unit or out of the louvers on the left side of cabinet. 3.
Operating Allow the To begin Instructions unit to reach operating the room temperature dehumidifier, follow before these operating. steps; Unit must be upright for one hour prior to operating. 1. Plug the power cord into a properly grounded 115 volt AC outlet. If the "BUCKET FULL" light is on, remove the bucket and re-install to reset the float switch, humidity setting lo RH% an jilter filter reset fan speed V L A timer ON-OFF humidity J 2.
Operating Instructions (continued) 3. After a few days when the Relative Humidity has declined, press the HUMIDITY A or V buttons to choose a value between 35% to 85%, so the room is kept at a comfortable humidity. Pressing the A or V buttons will change the humidity selection in 5% increments. After you have set the desired humidity, the readout will display the actual room humidity.
Operating Instructions (continued) 6. The TIMER function enables If the unit is running, then you to either selecting Delay Start Timer or Delay Stop the unit in the choice will turn the unit off in the hours that from 0.5 hour to 24 hours. will be set (Delay Stop). off, then selecting Timer will turn the unit on in the hours that will be set (Delay Start). TIMER setting: First press TIMER button, then adjust timer setting, by tapping or holding the change the delay timer at 0.
Removing Collected Water 1. Emptying the Bucket: a. When the bucket is full, the unit will shut down and the BUCKET FULL indicator will illuminate. filter reset fan V speed k b, Do not move the unit at this time otherwise c. Press sides of bucket d. Remove the bucket gently as shown to unclip water the bucket in the photographs A humidity timer ON-OFF J may spill on the floor. from the unit. below and empty the bucket. Discard water from bucket.
Removing Collected Water (continued) 2. Continuous Drainage: a. b. For continuous drainage operation, you will need a garden Uscrew the drain cap on the back side of the uint. (fig.Z) hose and a drain c. Insert connector d. e. Screw the garden hose onto the threaded portion of the drain connector. Make sure the hose is secure so there are no leaks. f. Direct the hose toward g. Place the end of the hose into the drain. h.
Before calling for service, review this list. It may save you time and expense. This list includes common occurrences that are not the result of defective workmanship or materials in this appliance. OCCURRENCE DEHUMIDIFIER OPERATE, SOLUTION DOES NOT Wall plug disconnected. House fuse blown Push plug or circuit firmly breaker into tripped. wall outlet. Replace fuse with time delay type or reset circuit breaker. The dryness level you selected has been reached.
Your appliance is covered by a limited one-year warranty and a limited 2-5 year warranty on the sealed system (the compressor, condenser, evaporator and tubing). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.
