..... iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii ¸ iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiil iiiiiiiiiiiiiiiiii_iiiiiiii_iiiiiii//ii//Miiiiiiii/ii/iiiii_i_%iiiiii iiiiiiiii_iiiiii'i'iiiiiiiiiiiiiiiiii!Jiiiiiiiiiiii/i/iiiiiiii_ii!iiiiiiiiiiii_ _iiii!iiiiiiiiiiiiiii_iiiiiiiiYmiiiiii_iiiiiiiiiiiiii_i_iii_ii_iiiiiii/i_ T How Operating In _J c3 t_4 www.frigidaire.c0m USA1-800-944-9044 www.frigidaire.
This USE A CARE MANUAL provides specific operating instructions for your model. Use the dehumidifier only as instructed in this USE & CARE MANUAL. These instructions are not meant to cover every possible condition and situation that may occur. Common sense and caution must be practiced when installing, operating, and maintaining any appliance. For Your Safety Avoid fire hazard or electric shock.
Locatiorl selecting a Location IMPORTANT: 1.Dehumidifiermust be operatedinan enclosedareato be most effective. Closealldoors, windows, and otheroutsideopeningsto the room. The effectiveness ofthe dehumidifier depends on the rate at which new moisture-laden air enters the room. 2. Place dehumidifier in a location that does not restrict airflow through the front of the unit or out of the louvers on the left side of cabinet. 3.
Operating Allow the Instructions unit to reach To begin operating room temperature the dehumidifier, before follow operating, steps: these Unit must be upright for one hour prior to operating. 1. Plug the power cord into a properly grounded 115 volt AC outlet. If the "BUCKET FULL" light is on, remove the bucket and re-install to reset the float switch. humidity setting RH% fil.ter reset fan speed v L A humidity timer ON=OFF J J 2. To turn the unit on, press the ON/OFF button.
Operating Instructions (continued) 3. After a few days when the Relative Humidity has declined, press the HUMIDITY A or V buttons to choose a value between 35% to 85%, so the room is kept at a comfortable humidity. Pressing the A or V buttons will change the humidity selection in 5% increments. After you have set the desired humidity, the readout will display the actual room humidity.
lll Operating Instructions (continued) 6. The TIMER function enables If the unit is running, then you to either selecting Delay Start Timer or Delay Stop the unit in the choice will turn the unit off in the hours that from 0.5 hour to 24 hours. will be set (Delay Stop). If the unit is off, then selecting Timer will turn the unit on in the hours that will be set (Delay Start).
Removing 1. Emptying a. Collected Water the Bucket: When the bucket is full, the unit will shut down and the BUCKET FULL indicator humidity will illuminate. setting RH% _==ean filter fitter reset fan speed V A ON-OFF timer L humidity J J b. Do not move the unit at this time otherwise c. Press sides of bucket d. Remove the bucket Discard water from bucket. gently as shown Water to undip water the bucket in the photographs is not potable may spill on the floor.
Removing Collected Water (continued) 2. Continuous Drainage: a. b. c. d. e. f. g. h. For continuous drainage operation, you will need a garden hose and a drain nearby to discharge the water into. Unscrew the drain cap on the back side of the unit. (fig.l) Insert the female threaded end of the hose onto the drain connector of the unit. (fig.2) Screw the garden hose onto the threaded portion of the drain connector. (fig.3) Make sure the hose is secure so there are no leaks.
Before calling forservice, reviewthislist.It maysaveyoutimeandexpense. Thislistincludes common occurrences thatarenot theresultofdefective workmanship ormaterials inthisappliance. OCCURRENCE DEHUMIDIFIER OPERATE. SOLUTION DOES NOT Wall plug disconnected. House fuse blown Push plug or circuit firmly breaker into wall outlet. tripped. Replace fuse with time delay type or reset circuit breaker. The dryness level you selected has been reached.
Your appliance is covered by a limited one-year warranty and a limited 2-5 year warranty on the sealed system (the compressor, condenser, evaporator and tubing). For one year from your original date of purchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used and maintained in accordance with the provided instructions.
