Complete Owner's Guide

Removing Collected Water

1. Emptying the Bucket:

a. When the bucket is full, the unit will shut down and the BUCKET FULL indicator will illuminate.

b. Do not move the unit at this time otherwise water may spill on the floor.

c. Press sides of bucket gently to unclip the bucket from the unit.

d. Remove the bucket as shown in the photographs below and empty the bucket.

e. Replace the empty bucket back into the unit and once seated correctly, the unit will start up again.

f. You should hear a click when the bucket is in the correct position

Discard water from bucket. Water is not potable and cannot be used for drinking.

WARNING

If the bucket full light does not extinguish, check that the float is correctly snapped in place as indicated by the diagram.

The foam embedded under the float(shown in the diagram below) is a functional part, which can not be removed.

NOTE:

LOW

LOCK

TIMER

CLEAN FILTER

MEDIUM

HIGH

POWER

CONTINUOUS

BASEMENT

LIVING SPACE

SLEEPING SPACE

BUCKET FULL

FILTER

TIMER

FAN

MODE

CONTI

NUOUS

SPEED

Operating Instructions

Float

Foam