Complete Owner's Guide

7
OPERATING INSTRUCTIONS
*In all Error Code instances, if Pressing the cancel button or turning power o at the breaker for 5
min. does not resolve the problem, contact the Frigidaire Customer Care Center at 1-800-944-9044.
Error Code
Displayed
Error Code*
Problem Solution
i10 A low ll has been
detected.
Look for a pinched water supply line, or water shuto
is not completely opened.
i20; i40; iF0 Clogged lters or a
restricted drain line has
been detected.
Check and clean both lters and sump area and check
for a pinched or blocked drain hose. If the drain line is
attached to a disposer, check that the knockout plug
has been removed.
i30 A leak or overow of
water has been detected
in the bottom pan.
Look for loose connections at the water inlet valve and
ensure the unit is properly leveled.
i50 A problem has been
detected with the drain
or wash motor.
Pressing the cancel button or turning power o at the
breaker for 5 min. should clear this error code and the
unit can be restarted.
If this does not resolve the problem, service will
need to be called.
i60 A problem has been
detected with the water
heating system.
iC0 A problem has been
detected with the
electronic control system.
Status Window
The STATUS window, available on some models, indicates the following activity:
User Instruction Code
1-24h Number of delay start hours.
The last hour will count down
in minutes.
CLOSE Close will scroll across the status
window indicating the door needs to
be closed.
MINUTES Number of minutes left in cycle
(1-199).
L0–L6. Level of Rinse Aid dosage.
Instruction
Code
Displayed
Problem/Condition Solution
Close This indicates the door
has been left open or not
properly latched.
Ensuring the door is properly latched will clear the
display. This does not indicate a problem with your
dishwasher and service will not need to be contacted.
PF Soft Power Failure: PF is displayed if a power outage occurs during a wash cycle. The
wash cycle will be paused temporarily and resume once power is restored if the door
has not been opened.
Hard Power Failure: A hard power failure means the unit will not operate until power
is restored. Pressing start within 18 hours of loss of power will resume power at the
point of cycle interruption.