Product Specifications Sheet

INSTALLATION SPECIFICATIONS
•
Product Shipping Weight (approx.) – 83 Lbs.
•
Voltage Rating – 120V / 60 Hz / 15 Amps (maximum 20 Amps if connected
with disposer)
•
Connected Load (kW Rating) @ 120 Volts = 1.44 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire service with
a separate ground wire. Appliance must be grounded for safe operation.)
•
Amps @ 120V = 10 Amps
•
Always consult local and national electric & plumbing codes. Meets
requirements of ASSE 1006 — integral air gap on supply. Dishwasher enclosure
requires that adjacent cabinets be square and plumb. Unit must be fully
enclosed on top, sides and back; and not support any part of enclosure.
•
For A.D.A. installation, (32 1/2") beneath 34"- high countertop may be
accomplished by adjusting toekick and leveling legs.
•
When installing unit adjacent to wall, cabinet or other obstruction that extends
beyond front edge of unit, allow 2" minimum clearance between opened door
and obstruction.
•
Do not install unit beneath cooktop, damage will occur.
•
Make sure location has required drain, water and electrical outlets to make
proper connections.
•
Air gap required if drain is connected to waste tee or disposer lower than 18"
above floor. If no air gap required, minimum 32"-high drain loop must be used.
Total drain hose length must not exceed 10' to drain outlet.
•
Electrical and water supplies should enter enclosure on floor, or through rear
or cabinet side walls, as shown in designated shaded area. Hot water line
may pass through same hole as electrical cable and drain hose; or through
additional 1-1/2" dia. hole designated to accommodate line.
•
Water connection located on left side of dishwasher. Install hot water inlet line
using no less than 3/8" O.D. copper and extend forward at least 18" from rear
wall with hand shut-off valve accessible beneath sink.
•
Water Pressure – Hot water line to dishwasher must provide between 20 and
120 pounds per square inch (psi).
Specifications subject to change. Accessories information available on the web at frigidaire.com / frigidaire.ca
Note: For planning purposes only. Always consult local and national electric, gas and plumbing codes.
Refer to Product Installation Guide for detailed installation instructions on the web at frigidaire.com / frigidaire.ca.
USA
•
10200 David Taylor Drive
•
Charlotte, NC 28262
•
1-800-FRIGIDAIRE
•
frigidaire.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
frigidaire.ca
23.6" (600mm)
minimum
23" (580mm)
minimum
32.5" (825mm)
minimum
Meets
requirements of
ASSE 1006
FFBD2420U 02/19
© 2019 Electrolux Home Products, Inc.
FFBD2420U S/W/B
DISHWASHER
24" BUILT-IN
Side View Front View
23.5” (598mm)22.6” (575mm)
32.4” 825mm