Specification

Accessories information available
on the web at frigidaire.com
USA
•
10200 David Taylor Drive
•
Charlotte, NC 28262
•
1-800-FRIGIDAIRE
•
frigidaire.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
frigidaire.ca
FFEW3025P 12/16 © 2016 Electrolux Home Products, Inc.
Specifications
subject to change.
Single Wall Oven Specifications
•
Product Shipping Weight (approx.) – 140 Lbs.
•
Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz
AC only electrical supply with ground required on separate circuit
fused on both sides of line.
•
Connected Load (kW Rating) @ 240 / 208 Volts = 3.7 / 2.8 kW
•
Amps @ 240 / 208 Volts = 15.4 / 13.5 Amps
•
Recommended Circuit Breaker – 20 Amps
•
Always consult local and national electric codes.
•
Minimum 21" clearance for oven door depth when open.
•
Suggested distance from floor is 31". Minimum required distance
is 4-1/2".
•
Minimum 24" deep cutout dimension is critical for proper installation,
to ensure that oven’s faceplate will fit flush against cabinet front.
•
To adapt oven to fit cutout height greater than 28-1/8", add one
2"-wide wood shim of appropriate height to each side of opening
under oven side rails. Lifting oven will hide larger cutout opening
at top and oven’s 1"-high bottom trim will hide shims at bottom.
(Standard 1"-High Bottom Trim included.)
•
To adapt oven to fit cutout height greater than 28-5/8", optional
3"-High Bottom Trim available.
•
Full oven base of solid plywood or similar material required,
capable of supporting 200 Lbs.
•
Base must be level and cabinet front must be square.
•
Single Wall Oven is NOT approved to be used in stackable or
side-by-side installation.
•
Single Wall Oven is approved to be used alone in under-counter
installation or beneath any approved Frigidaire® gas or electric
cooktop. (Refer to Gas or Electric Cooktop Installation Over 30" / 27"
Electric Single Wall Oven Specifications pages on web.)
•
Single Wall Oven is approved to be used in combination with any
Frigidaire® Warmer Drawer. (Refer to model-specific Warmer Drawer
product page for Combination Installation Specifications.)
•
Single Wall Oven is approved to be used in combination with
any Frigidaire® Built-In Microwave Oven.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Optional Accessories
•
3"-High Stainless Steel Bottom Trim – (PN # 318259707).
•
3"-High White Bottom Trim – (PN # 318259703).
•
3"-High Black Bottom Trim – (PN # 318259704).
•
10'-Long Armored Power Cable – (PN # 903056-9010).
30" Single Electric Wall Oven
Baseline
28
1
/4"
29"
(includes
1" bottom
trim)
Spacer
24
3
/4"
30"
27
3
/16"
Allow at least
21" clearance
for door depth
when open
Power
supply
location
(left
bottom
rear)
*Critical di
mension – MUST be applied
**
F or cutout height greater
t han 28
1
/ 8 " add one 2"-wide
wood shim of appropriate height to each side of op
ening
under oven si
de rails.
Lifting oven will hide larger cutout
openi
ng at top and oven’
s 1"-high bott
om trim will hide
shims at
bottom.
(Optional 3"-high bottom trim available
for cutout
height greater
t han 28
5
/ 8 " .)
3"
Electrical
junction
box location
2" min.
1
1
/2"
min.
27
1
/4"
min.
28
5
/8"
max.
Full base
required to
support
200 lbs.
4" x 4"
opening
to route
armored
cable
24" min.*
(critical
dimension)
2"-wide
wood spacers
(if needed)**
31"
suggested
distance
4
1
/2"
min.
required
30
1
/8"
min.
28
1
/8" min.
29" max.
Single Wall Ovens
FFEW3025P S / W/ B 30" Electric