Complete Owner's Guide
27
CARE AND CLEANING
Removing and Replacing the Oven Door
To remove oven door:
CAUTION
The door is heavy. For safe, temporary storage, lay the
door flat with the inside of the door facing down.
1. Op
en oven door completely, horizontal with floor (See
Figure 16).
2. Pu
ll the door hinge locks on both left and right door
hinges down from the oven frame completely towards
the oven door (See Figure 17). A tool such as a small
flat-blade screwdriver may be required.
3. F
irmly grasp both sides of oven door along the door
sides. Do not use the oven door handle (See
Figure 18).
4. Clo
se the door to approximately 10 degrees from the
door frame (See Figure 18).
5. Lif
t the oven door hinge arms over the roller pins
located on each side of the oven frame (See Figure 19).
To replace oven door:
1. F
irmly grasp both sides of oven door along the door
sides. Do not use the oven door handle (See
Figure 18).
2. Hol
ding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller
pins located on each side of the oven door frame (See
Figure 18 and Figure 19). The hook of the hinge arms
must be fully seated onto the roller pins.
3. F
ully open the oven door, horizontal with floor (See
Figure 16).
4. Pu
sh the door hinge locks up towards and into the oven
frame on both left and right oven door hinges to the
locked position (See Figure 17).
5. Clo
se the oven door.
IMPORTANT
Special door care instructions - Most oven doors contain
glass that can break. Do not hit the glass with pots, pans,
or any other object. Scratching, hitting, jarring, or
stressing the glass may weaken its structure, causing an
increased risk of breakage at a later time. Do not close
the oven door until all of the oven racks are fully in place.
Figure 16: Door hinge location
Oven door
hinge
locations
Figure 17: Door hinge locks
L
O
C
K
Figure 18: Holding door for removal
about
10°
hinge
oven
door
Figure 19: Replacement and location of hinge arm and
roller pin
roller
pin
hinge
arm