Aftermarket Installation Information

2
Ice Maker Installation Instructions
1. Unplug refrigerator from electrical outlet.
2. Lift the freezer shelf up and out. Set aside.
See Figure 1.
3. Remove water inlet and electrical cover, located
on the inside of the unit, by inserting a flathead
screwdriver on right side of opening in the small
cover. Push to the left to disengage the snap.
See Figure 2
4. Locate dimples in the freezer liner for screw
placement (a flashlight may help). Align the
shoulder screws with the dimples. Push the
screws to penetrate the freezer liner and drive the
screws in until they are tight against the liner. Use
2 screws on the left side wall, and 3 on the top of
the liner. See Figure 3.
5. Insert the ice maker connector and wire through
the hole in the middle of the water inlet and
electrical cover. See Figure 4.
Slide the ice maker onto the 2 side wall shoulder
screws. The ice maker will snap into place.
See Figure 6.
6. Plug the ice maker in the electrical connector
on the back wall. Then install the water inlet and
electrical cover back in position by inserting the
tab on the left side into the slot and push in the
right side to make the snap engage. See Figure 5.
Figure 1
Figure 2
To Ceiling
To Wall
Install 5
Shoulder
Screws
Figure 3
Figure 4
Align Water
Inlet
Plug
Electrical
Connector
Figure 5
Figure 6