Installation Guide

10
Laundry Center Dimensions
47.5” (120.5 cm)
31.5” (80 cm)
77”
(196.5 cm)
23”
(58.5 cm)
38”
(96.5 cm)
55.75”
(141.5 cm)
43.5”
(110.5 cm)
4 in. (102 mm)
exhaust vent
on rear of unit
center line height
for 4 in. (102 mm)
exhaust outlet
drain hose reten-
tion clamp on rear
of washer
2
water supply
connection on
rear of washer
power cord
attachment
location on rear
of unit
1
17.6”
(45 cm)
1
Power supply cord length on gas unit approximately 60 inches (152.5 cm).
2
Loose drain hose length beyond clamp approximately 51.5 inches (131 cm).
45”
(114 cm)
9.4”
(24 cm)
5.5”
(14 cm)
gas supply
pipe on rear
of gas unit
MINIMUM INSTALLATION CLEARANCES - Inches (cm)
SIDES REAR TOP FRONT
Alcove
0”
(0 cm)
0”
(0 cm)
1”
(2.5 cm)
n/a
Closet
0”
(0 cm)
0”
(0 cm)
1”
(2.5 cm)
1”
(2.5 cm)
Clearance requirements
0”
(0 cm)
0”
(0 cm)
1”
(2.5 cm)
1”
(2.5 cm)
INSTALLATION REQUIREMENTS
IMPORTANT
DO NOT INSTALL YOUR LAUNDRY CENTER:
1 In an area exposed to dripping water or outside weather conditions. The ambient temperature should never
be below 60° F (15.6° C) to maximize detergent effectiveness.
2 In an area where it will come in contact with curtains, drapes, or anything that will obstruct the fl ow of
combustion and ventilation air.
3 On carpet. Floor MUST be solid with a maximum slope of 1 inch (2.5 cm). To minimize vibration or movement,
reinforcement of the fl oor may be necessary.
27” (68.5 cm)
WARNING
EXPLOSION HAZARD
Do not install the dryer where gasoline or other
fl ammables are kept or stored. If the dryer is installed
in a garage, it must be a minimum of 18 inches (45.7
cm) above the fl oor. Failure to do so can result in
death, explosion, fi re or burns.