Installation Guide

13
Unpacking Instructions
1. If foam tub block has been removed, reinsert it now
and retape the lid securely.
2. Carefully cut the front and back corners of the left
side of the remaining cardboard.
3. With help from a second person, carefully tip the
laundry center slightly to the left as shown in the
picture below. First remove the foam shipping support
to the right side only and then remove the foam
base. Save these items for future use.
4. Carefully lower the laundry center to an upright
position and remove the tape holding the lid shut.
Remove the foam tub block and other tub contents.
5. From the back of the washer, remove the wire
shipping clip securing the drain hose.
6. DO NOT remove the PLASTIC CLAMP which secures
the drain hose to the right side of the washer
backsheet. It helps form a standpipe to prevent water
siphoning.
2
3
1
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one
person move or lift the appliance.
NOTE
If the laundry center is to be transported at a later
date, the tub blocking pad, foam base and tub support
should be retained.
IMPORTANT
To prevent vibration, possible machine damage and
maximize performance, the following steps must be
completed.
UNPACKING LAUNDRY CENTER
7. Carefully move the laundry center to within 4 feet of
the fi nal location for the start of the installation.
WIRE CLIP
PLASTIC
CLIP
FRONT
Pull out
RIGHT side
ONLY!