Installation Instructions

3
MOUNT THE M ICROWAVE
OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECO MMEND THAT TWO PEOPLE
INSTALL THIS MICROWAVE OVEN.
NOTE: If your cabinet is metal, use th e nylon
grommet aroun d the power cord hole to preven t
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabin et fron t h angs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are
not used, case damage may occur from
overtightening screws.
Insert a self-aligning screw through top center
cabin et hole. Temporarily secure th e oven by
turn in g the screw at least two full turns after the
threads have engaged. (It will be completely
tigh ten ed later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
2
Rotate fron t of oven
up again st cabinet
bottom.
NOTE: When mounting the
microwave oven, thread
power cord through h ole in
bottom of top cabinet. Keep
it tigh t th rough out Steps
1–3. Do not pinch cord or
lift oven by pulling cord.
Lift microwave, tilt it
forward, and h ook
slots at back bottom
edge on to four lower
tabs of moun ting
plate.
1
CHECK FOR PROPER
DAMPER OPERATION
Exhaust Adaptor
Blow er Plate
Damper
Back of
M icrow ave
• Make sure tape securing damper is removed and
damper pivots easily before mounting microwave.
• You will n eed to make adjustments to assure proper
alignment with your house exhaust duct after the
microwave is installed.
A3.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
TOP EXHAUST
Secure blower un it to microwave with the screw
5
removed in Step 1. Make sure th e screw is tigh t.
Replace blower plate with th e screw removed in
Step 1. Make sure th e screw is tigh t.
Back of
M icrow ave
6
7
Back of
M icrow ave
Guide
Adaptor
Locking Tab
damper swings freely.
Attach the exhaust adaptor to the top of the
blower plate by slidin g it into th e guides
of the
blower plate.
Push in securely un til it is in the locking
tabs.
Take care to assure that the damper h in ge
is
installed so that the
A4.
A5.
Installation Instructions
EN-14
IMPORTANT: Do not grip or use the handle
or heat shield during installation. Do not
remove the cardboard spacers between the
heat shield and door.