Installation Instructions

PLACEMENT OF THE MOUNTING PLATE
1
Installation Instructions
Find the studs, using one of th e following
methods:
A. Stud finder – a magn etic device wh ich
locates n ails.
B. Use a h ammer to tap lightly across the
moun ting sur face to find a solid sound.
This will indicate a stud location .
After locating th e stud( s), find the center by
probin g the wall with a small n ail to fin d the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16w ( 40.6 cm) or 24w ( 61 cm) from this mark.
Draw a line down the center of the studs.
TH E MICRO WAVE MUST BE CONNECTED TO
AT LEAST O NE WALL STUD.
1
Fold back all 4 carton flaps fully again st carton
sides. Th en carefully roll th e oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
REMOVING THE M ICROWAVE
OVEN FROM THE CARTON/
REMOVING THE M OUNTING
PLATE
FINDING THE WALL STUDS
B
.
A
.
2
Wall
Studs
Center
3
Carton
Pull the carton up and off th e oven.
2
Styrofoam
3
1
Screws
Screws
Mounting Plate
5
4
Cut the middle of the outer protective plastic bag to
r
emove
the
ounting late
m
p
Filters and Turntable
Ring below glass tray
Exhaust Adapter
Small Hardware Bag
Glass Tray
Shelf ( For some
Remove the installation instruction s,use and care,
exhaust adapter, turntable ring, shelf, filters, glass
Do not remove
the Styrofoam protecting the fron t of the oven.
Remove the screws from each end of the mounting
plate. This plate will be used as the rear wall template
ba
g.
and for moun ting. Reinstall the screws into the holes
wh ere they were removed.
tray and th e small hardware
EN-6
models)