Installation Guide

Inst

allation Instructions

Installation Instructions

EXHAUSTING HOT AIR

1. Extend either side of the hose (Fig. 3) and screw the hose to

adaptor A (Fig. 4) .

2. Extend the other side of the hose and screw it to adaptor B (Fig. 5).

3. Slide the assembly onto unit (Fig. 6).

4. Affix the adaptor B into the window slider kit and seal. (Fig. 7&8)

In the COOLING Mode the appliance must be placed close to a window or

opening so that the warm exhaust air can be ducted outside.

First position unit on a flat floor and make sure there’s a minimum of 12"

clearance around the unit, and is within the vicinity of a single circuit outlet

power source.

The hose can be extended from its original length of 15

" up to 59", but it is

the best to keep the length to minimum required. Also make sure that the

hose does not have any sharp bends or sags. (Fig. 9)

Fig. 7

Window Slider Kit

Minimum:26.6"(67.5cm)

Maxmum:48.5"(123cm)

Fig. 8

Window Slider Kit

Minimum:26.6"(67.5cm)

Maxmum:48.5"(123cm)

Fig. 4

Fig. 5

Fig. 3

Extend the side of hose

Vertical

window

Horizontal

window

Fig. 9

Fig. 6

Slide onto

PAGE 1
Installation Instructions Installation Instructions EXHAUSTING HOT AIR In the COOLING Mode the appliance must be placed close to a window or opening so that the warm exhaust air can be ducted outside. First position unit on a flat floor and make sure there’s a minimum of 12" clearance around the unit, and is within the vicinity of a single circuit outlet power source. Extend the side of hose 1. Extend either side of the hose (Fig. 3) and screw the hose to adaptor A (Fig. 4) . 2.
PAGE 2
Installation Instructions Installation Instructions (continued) Installation in a double-hung sash window 1. Cut the foam seals(adhesive type) to the proper lengths and attach them to the window and stool. (Fig. 10) 2. Open the window sash and place the window slider kit on the window stool (Fig. 11). Attach the window slider kit to the window stool. Adjust the length of the window slider kit according to the width of window. Screw down the two screws on the window slider kit. See Fig.11.