Wiring Diagram/Installation Instructions

REVERSING DOOR

1 Open the door and begin removing the four screws that

attach the hinge to the front panel door opening. Start

by only removing one screw per hinge. Then only loosen

the two remaining screws while ﬁ rmly holding the door to

prevent damage to hinge, front panel or door. After the

remaining screws are loosened, continue to remove all.

2 Place door on a towel (front side down) to prevent

scratches to paint. Remove all screws on all edges of door.

1 Be sure you have adequate swing area before

reversing door.

2 You will need a screw driver with a Phillips bit.

3 Protect ﬂ at work surface, such as top of dryer or ﬂ oor

near dryer, with a soft cloth or towel.

4 Be sure dryer is unplugged from power source!

Tools needed:

Your dryer is designed so the door swing may be reversed at any time without additional parts. Conversion is accomplished by

transferring hinges and door strike to the opposite sides of the cabinet.

Screwdriver with

Phillips bit

FRONT PANEL

HINGE SCREWS (x 4)

WARNING

ELECTRICAL SHOCK HAZARD

Failure to disconnect power source before

servicing could result in personal injury or

even death.

3 Separate inner door from outer door and rotate outer door

180 degrees.

4 Reinsert inner door to outer door and re-install hinges and

all screws removed earlier.