Installation Instructions

#8 White Westinghouse/Frigidaire/

Carrier 52F Series

Wall Sleeve Brands:

1. Remove existing rear grille as shown on Page 3 of this manual and

replace with provided louvered rear panel. Install as shown here.

80º

50º 50º

Rear Louvers

80º

Top View

16"+ 17-1/2" Deep

2. Attach (1) 1" x 3/8" x 25" long seal in the center at the top of the sleeve.

Remove the backing paper and press into position.

5. Center unit & gently slide unit into sleeve.

6. Before sliding all-the-way back, remove 2nd screw from front on left

side of unit.

7. Remove the plastic washer from the screw.

9. Slide the unit completely to the rear to ensure a good seal, making sure

the ground wire does not become tangled.

10. Seal & Frame the unit as described on the last page of these

instructions.

8. Screw and attach the other end of the ground wire from sleeve to the

unit as shown in picture. Make sure that the toothed washer is against

the cabinet.

3. Attach (2) 1" x 3/8" x 14" seals to the left and right sides of the sleeve.

4. Attach (1) 1" x " x 14" long seal vertically 3.5" from the left side of the

sleeve. Attach the other 1" x " x 14" long seal 3" from the right side of

the sleeve.

NOTE: You may need to drill holes in flange of existing sleeve to match

new rear grille

11. If you have difficulty with mounting the grill to the sleeve, follow the

instructions for direct mounting on Page 13.

4.5"

4.5" 4"