Installation Guide

8
INSTALLATION INSTRUCTIONS
Connecting drain hose to washer
1 With the spring clamp already installed, place
the drain hose elbow over the pump outlet at the
lower rear of the washer. Ensure the hose elbow is
completely and squarely seated to the pump outlet
before using pliers to move the spring clamp into
place.
IMPORTANT
Inspect rubber fl ap on pump outlet. Ensure it is in
place and not folded under or torn.
2 “Thread” the end of the drain hose up through
either of the outer, larger “D” ring retainers below
the top panel.
3 Locate the anti-siphon ring shipped with your
washer. Place it over the end of the drain hose and
slide it past the fi rst ring of “accordion” ribs.
DRAIN PUMP
OUTLET
SPRING CLAMP
ANTI-SIPHON
DISC
SLIDE DISC
TO HERE
SLIDE CLAMP
TO HERE
DRAIN HOSE
RETAINER