Complete Owner's Guide

23
FILTER REPLACEMENT
PurePour™ Water Filter
Keep safe, great-tasting water flowing
with a PurePour water filter. Using a Pure-
Pour water filter:
• Makes Safe Water Second Nature
PurePour water filters are certified
to reduce contaminates* and keep
great-tasting water flowing for you
and your family.
• Produces Purity You Can Trust
Know for certain your PurePour water
filter is a protector. Counterfeits and
knockos put your refrigerator and
health at risk. Frigidaire Genuine Fil-
ters are the smarter, safer choice.
• Every Drop Gives Back
Partnered on sustainability eorts,
the use of a PurePour water filter
helps cut back on the cost and use of
plastic used to produce and package
bottled water
*For the complete list, please see Perfor-
mance DataSheet on Frigidaire.com
Do not use with water that is microbiologi-
cally unsafe or of unknown quality without
adequate disinfection before or after the
system. Use systems certified for cyst
reduction on disinfected waters that may
contain filterable cysts.
Test & certification results:
• Rated Capacity - 125 gal/453 L for
PurePour and ice and water filter
• Rated service flow - .50 gal/min.
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 lbs/in.²
• Recommended Minimum Operating
Pressure: 30 lbs/in²
To replace your PurePour
water filter:
It is not necessary to turn the water
supply o to change the filter. Be ready
to wipe up any small amounts of water re-
leased during the filter replacement.
1. Turn O the ice maker.
2. Remove the filter by pushing on the
end/face of the filter.
3. Slide the old water filter cartridge
straight out of the housing and
discard it.
4. Unpackage the new filter cartridge.
Using the alignment guide, slide it
gently into the filter housing until it
stops against the snap-in connector
at the back of the housing.
5. Push firmly until the cartridge
snaps into place (you should hear a
click as the cartridge engages the
snap-in connector).
6. Press a drinking glass against the
water dispenser while checking for
any leaks at the filter housing. Any
spurts and sputters that occur as
the system purges air out of the
dispenser system are normal.
7. After filling one glass of water, con-
tinue flushing the system for about
4 minutes.
8. Turn On the ice maker.
9. Press and hold the Water Filter reset
button on the Ice & Water Dispenser
control panel for 3 seconds. When
the display changes from red to
green, the status has been reset.
Ordering Replacement Filters
To order your replacement filters, please
visit our online store at Frigidaire.com, by
calling toll-free at 1 [phone], or by
visiting the dealer where you purchased
your refrigerator. Frigidaire recommends
that you order extra filters when you first in-
stall your refrigerator, and that you replace
your filters at least once every 6 months.
Here are the product numbers to request
when ordering:
PurePour Water Filter
Part# FPPWFUO1™
Replacing the
Water Filter
The water filter is
located at the top
right side of the re-
frigerator compart-
ment. In general,
you should change
the water filter
every 6 months to ensure the highest
possible water quality. Water Filter Status
on the user interface prompts you to
replace the filter after a standard amount
of water (125 gal/453 L for PurePour)
has
flowed through the system.
If you have not used your refrigerator for a
period of time (during moving for exam-
ple), change the filter before reinstalling
the refrigerator.
More about your Advanced
Water Filter
The PurePour ice and water filter sys-
tem is tested and certified to NSF/ANSI
Standards 42, 53, 401 and CSA B483.1
for the reduction of claims specified
on the performance data sheet. Visit
Frigidaire.com
for more information.

NOTE
When you order your replacement filter,
please reorder the same filter type
currently in your refrigerator.