Complete Owner's Guide

33
SETTING OVEN CONTROLS
Steam Clean
The Steam Clean feature oers a chemical free and
time saving method to assist in the routine clean-
ing of small and light soils.
CAUTION
• Do not add bleach, ammonia, oven cleaner, or
any other abrasive household cleaners to the
water used for Steam Clean.
• Before cleaning any part of the oven, be sure
all controls are turned o and the oven is cool.
The oven may be hot and can cause burns.
Be sure the oven is level and cool before starting
Steam Clean. If the oven temperature is above
room temperature a triple beep will be heard and
the function will not start. Steam Clean produces
best results when started with a cool oven.
To set a Steam Clean cycle:
1. Remove all racks and oven accessories.
2. Scrape or wipe loose debris and grease from
the oven bottom.
3. Pour 1 cup of tap water onto the oven bottom.
(Figure 18) Close oven door.
Notes:
• Opening the oven door during the steam clean
cycle prevents the water from reaching the
temperature needed to clean.
• For best results, clean oven immediately after
the cycle is complete. Steam clean works best
for soils on the oven bottom.
• A non-abrasive scouring pad, stainless steel
sponge, plastic scraper, or eraser style cleaning
pad (without cleaner) can be used for dicult
soils. Moisten pads with water before use.
• Place a paper towel or cloth in front of the
oven to capture any water that may spill while
wiping out.
• Do not leave the residual water in the oven for
any length of time.
• Some condensation or water vapor may appear
close to the oven vent and the oven door glass.
This is normal. The oven gasket may become
damp; do not wipe dry.
• Local water sources often contain minerals
(hard water). If hard water deposits occur, wipe
cavity with a 50/50 solution of water and vine-
gar or 50/50 solution of lemon juice and water.
4. Press steam clean.
5. Press
or to activate. St Cn will ap-
pear in the display.
6. The oven will start automatically and the dis-
play will show the time remaining in the Steam
Clean cycle. Do not open the door during this
time. If door is open while in steam clean (d-O)
will appear in the display.
7. When the steam clean cycle is complete an
alert will sound and the END message will
show in the display. Press OFF to return to
the clock. Press OFF at any time to cancel the
Steam Clean.
8. Take care opening the door when the steam
clean is finished. Stand to the side of the oven
out of the way of escaping vapor.
9. Wipe oven cavity and bottom. Do not clean
oven door gasket (Figure 19). Avoid leaning or
resting on the oven door glass while cleaning
cavity.
Figure 18: Add one cup of tap water to oven
bottom
Figure 19: Clean around gasket being careful to
not rub the gasket.