Use & Care Manual Assembly Instructions Included 27" Stainless Steel Outdoor Grill with Electronic Ignition Welcome/Product Registration ............ 2 General Safety Instructions .................. 3 Fligid alie Grill Features and Components ...... 4-12 Grill Assembly ................................ 13-14 Gas Requirements Pre-Operation Leak Testing ........... 15-19 Lighting the Grill ............................. 20-21 Using the Grill Using the Rotisserie & Side Burners Fligid alie ................
Welcome & Congratulations Congratulations on your purchase of a new grill! We at Electrolux Home Products are very proud of our product and we are completely committed to providing you with the best service possible. Your satisfaction is our #1 priority. Questions? 1-800-Frigidaire Please read this Use & Care Manual very carefully. It contains valuable information on how to properly maintain your new grill.
General Safety Instructions IMPORTANT SAFETY INFORMATION - Read this manual carefully before using your grill to reduce the risk of fire, burn hazard or other injury. - Extreme care should be used because of the high temperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED. - This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids.
Grill Features: FD27 FD27LKEC 1 2 3 7 8 9 4 5 6 10 11 12 13 1. Control knob: Main burner 9. Rear infrared burner 2. Control knob: Rear infrared burner 10. Tool bar 3. Control knob: Main burner 11. Electronic igniter: side burner 4. Electronic igniter: Main and rear infrared burner 12. Control knob: side burner 5. Control panel 13. Front door 6. Control knob: Main burner 7. Hood handle 8.
Grill Assembly SIDE SHELF ATTACHMENT 1. 2. 3. 4. 5. Remove the side burner together with the gas hose from the front door. Make sure the hose is in good condition before installing the side burner (See Fig. 1) The screws used to attach the side shelf and side burner are already screwed into the two side panels. Remove the screws from the side panels. (See Fig. 2) Align with the holes in the left side shelf, and then re-attach into the holes on the left side panel of the grill.
Grill Assembly SIDE BURNER HANDLE ASSEMBLY 1. 2. To assemble the side burner lid handle, open the lid then cut off the plastic tie in the screw hole. Install the handle in the lid as shown. (See Fig. 3) Remove the two screws from the handle. Align with the holes in the side burner, then re-attach into the holes on the stand of the handle, and tighten up the screws. (See Fig. 4) Fig. 3 Fig.
Gas Requirements GENERAL INFORMATION Never attach an unregulated gas line to the appliance. Connection to an unregulated gas line can cause excessive heat or fire. Verify the type of gas supply to be used – either Natural Gas (N.G.) or Liquid Propane (L.P.) – and make sure the serial plate agrees with that of the supply. Conversion kits are available separately for an additional cost which will enable you to convert your grill from L.P. to N.G. or to convert your grill from N.G. to L.P.
Gas Requirements INSTALLATION OF NATURAL GAS REGULATOR 1. 2. 3. The Natural Gas regulator has been attached to the manifold. Attach the gas hose to the regulator as shown. (See Fig. 5) Put the gas hose through the hole on the back of the cart panel. (See Fig. 6) Link a quick-connect fitting to the hose by hand. Quick-connect fitting not included. (See Fig. 7) Fig. 5 Fig. 6 Fig.
Gas Requirements L.P. GAS INSTALLATION Frigidaire Gas Grills that are set to operate with L.P. gas come with a high capacity hose and regulator assembly. (Note: Only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assemblies specified by Frigidaire). This assembly is designed to connect directly to a standard 20 lb. L.P. cylinder. L.P. cylinders are not included with the grill. L.P.
Gas Requirements CONNECTION: Your grill is equipped with gas supply orifices for use only with liquid propane gas. It is also equipped with a high capacity hose/regulator assembly for connection to a standard 20 lb. L.P. cylinder (18-1/4" high, 12-1/4" diameter). To connect the L.P. gas supply cylinder: (See Fig.8). 1. Make sure tank valve is in its full “OFF” position (turn clockwise to stop). 2. Check tank valve to ensure it has proper external male threads (type 1 connection per ANSI Z21.81). 3.
Pre-Operation Leak Testing GENERAL INFORMATION Although all gas connections on the grill are leak tested prior to shipment, a complete gas tightness check must be performed at the installation site due to possible shifting during shipment, installation or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks and immediately check the system if the smell of gas is detected. BEFORE TESTING Do not smoke while leak testing. Extinguish all open flames.
Lighting the Grill BEFORE LIGHTING Do not attempt to “Light” the grill if the odor of gas is present!! Important! Before Lighting... Check the gas supply line for cuts, wear or abrasion. Always keep your face and body as far away from the grill as possible when lighting. GRILL BURNER LIGHTING Lighting the Grill with the Electronic Igniter 1. Make sure all control knobs are in the “OFF” position. 2. Open the gas supply valve located on top of your L.P. tank. ATTENTION: When turning the L.P.
Lighting the Grill MATCH LIGHTING 1. If the burner will not light after several attempts then the burner can be match lit. 2. If you have already attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. Keep your face and hands as far away from the grill as possible. Insert a lit extended match or lighter through the cooking grids to the burner. Press the control knob and rotate left to the “HIGH” setting, and continue to press the knob until the burner ignites.
Using the Grill GRILL LOCATION Do not use the grill in garages, breezeways, sheds or any enclosed area or under overhead combustible construction. Never operate the grill in enclosed areas as this could lead to a carbon monoxide buildup, which could result in injury or death. Place the grill on a level surface. Avoid moving the grill while it is operation. NOTE: The grill will operate best if it is not facing directly into the wind.
Using the Rotisserie & Side Burners (Optional ROTISSERIE KIT to use with back infrared burner must be purchased separately) The grill rotisserie system is designed to cook items from the back using infrared heat. The rotisserie burner is an infrared type which provides intense searing radiant heat. Preferred by chefs over other cooking methods, this intense heat sears in the natural juices and nutrients found in quality cuts of meats.
Using the Rotisserie & Side Burners ROTISSERIE LIGHTING Open the lid. Push and turn the control knob for the rotisserie counterclockwise to the “HIGH” position. Wait 5 seconds. Then press and hold the electronic igniter button. You should Hear a snapping sound. If the burner does not light in 4 seconds, turn the control knob to “OFF” and wait 5 minutes before trying again. Once lit, turn the control knob to the desired setting. (See Fig.
Care & Maintenance DRIP TRAY The drip tray located below the grill, inside the cart, should be cleaned periodically to prevent heavy buildup of debris. NOTE: Allow the drip tray to cool before attempting to clean. Important: Do not leave the grill outside during inclement weather unless it is covered (cover sold separately). Rain water can collect inside the grill, the grill cart or the drip tray if left uncovered.
Troubleshooting Your Grill GENERAL TROUBLE SHOOTING You should inspect the burners at least once a year or immediately if any of the following conditions occur: • The smell of gas. • Flames appearing mostly yellow. (Some yellow at the tips is OK) • The grill will not get hot enough. • Burners make a snapping noise. • The grill heats unevenly. SPIDER AND INSECT WARNING Spider and insects can nest in the burners of this or any other grill and cause the gas to flow from the front of the burner.
Troubleshooting Your Grill PROBLEM SOLUTION Grill will not light with a match or low heat with dial set to “High” position. • Is your gas supply fully turned on? • If this is an L.P. grill is there gas in your tank? Check your gas level. • If this is an L.P. grill, shut off gas supply, disconnect gas line at tank; reconnect the line to the tank. • Make sure all the knobs are in the off position. Open the gas supply valve on the L.P. tank very slowly 1/4 turn, then open fully (at least two full turns).
Warranty LIMITED LIFETIME WARRANTY Frigidaire grills have a limited lifetime warranty on all stainless steel panels, a limited 3 year warranty on stainless steel burners, including labor within one year of the date of purchase; and a limited 1 year warranty on all other parts, labor included. In the U.S.A., your appliance is warranted by Electrolux Home Products North America. We authorize no person to change or add to any of our obligations under this warranty.