Use and Care Guide

Ice Maker Installation Instructions

1. Unplug refrigerator from electrical outlet.

3. Remove water inlet and electrical cover, located on the

inside of the unit, by inserting a athead screwdriver on

left side of opening in the small cover. Push to the right

to disengage the snap.

4. Locate dimples in the liner for screw placement (a

ashlight may help). Insert 5 shoulder screws in the

freezer: 2 screws on the left side wall, and 3 on the top

of the liner. Screw until shoulder screws are ush with

the liner.

To Ceiling

To Wall

Install 5

Shoulder

Screws

5. For 30” wide refrigerator install bracket onto ice

maker. Ice maker will slide onto mounting features

on bracket and snap into place. The locking feature is

located on the rear of the ice maker.

6. Plug the ice maker in the electrical connector on the

back wall.

Align Water

Inlet

Plug

Electrical

Connector

Make sure the ice maker water channel is under the

water ll tube, and then slide the ice maker on the 2 side

wall shoulder screws. The ice maker will snap into place.

2. Lift the freezer shelf up and out. Set aside.

Fill Tube and IM Water Channel

28” wide refrigerator

Use the ice maker only

Locking

Feature

30” wide refrigerator