Use and Care Guide

3
Ice Maker Installation Instructions
8. To install the ice bucket, the freezer shelf needs to be
in the lowest position. Slide the ice bucket between the
side wall and the right side of the ice maker housing
positioned on the shelf.
9. Locate the Ice maker installation label on the rear
outside right top corner of the refrigerator. Cut the label
on the dashed lines, and push aps inward until they
stick to the unit.
7. Install ice maker housing onto shoulder screws on the
top of the unit until it locks into place with a snap.
10. Install the water line by screwing the nut on the end
of the tube onto the water inlet. Tighten the nut with
needle nose pliers to a snug +¼ turn.
11. Install the 2 water line clips on the unit evenly spaced
inside the depressed area located under the water inlet.
Insert the water line tube into the clips.
Cut on dashed lines
and push in on flaps
Water
Line
Clip
Water
Inlet
*If you have a unit with an access cover,
continue to page 4 for additional installa-
tion instructions. For a unit without an ac-
cess cover, continue to page 5.
Units with access cover
Units without access cover