Use and Care Guide

4
Ice Maker Installation Instructions (with access cover)
Water
line
Power cord

NOTE
Ensure power cord is aligned with the notch at the
bottom of the access cover and the water line is located
on the notch at the top right of the cover.
15. Plug connector on water valve wire harness into the con-
nector at top of appliance compartment. Install the water
valve clip at the bottom right side of the unit, and route
and attach the water valve harness into the clip.
16. Remove water valve punch out in access cover with pliers.
CAUTION
Wear gloves and use extreme CAUTION when handling
the access cover.
Plug water tube
into water valve
Remove 8 Screws
13. Place the water tube into the bottom outlet of the water
valve. The tube should be pushed into the valve up to
the black line marked on the tube. Check to make sure
the tube is installed correctly.
12. Remove 8 screws from access cover located at the
bottom rear outside of the unit. Set aside.
14. The water valve location has pre-drilled holes on the
right rear of the unit. The water line should be oriented
down when valve is installed. Install the water valve
using a ¼” hex head driver, install the 2 hex head
screws. Tighten screws to a snug +¼” turn.
17. Reinstall the access cover by hooking cover onto the
bottom ange of the cabinet , then lift up to align with
the screw locations on the cabinet. Install the screws
starting with the 2 on the left side, then the right side ,
nish with the center screws.
18. Connect the household water line to the water valve.
Follow instructions on page 7.