Installation Instructions

USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill h oles for th e top support screws, a
hole large enough for th e power cord to fit through ,
and a cutout large en ough for the exhaust adaptor.
A2.
• Read th e instructions on th e TOP CABINET
TEMPLATE.
• Tape it undern eath the top cabinet.
• Drill th e holes, following the in structions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles wh en drilling holes
in the cabinet bottom.
Installation Instructions
A3.
Remove the screw that holds the blower plate
to the microwave. Remove and save th e screw
holdin g the blower motor to the microwave.
Blow er Plate
Blow er Motor
Screw
Back of
M icrow ave
2
End B
End A
Carefully pull out the blower unit. Th e wires
will exten d far en ough to allow you to adjust
the blower un it.
1
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
TOP EXHAUST
Roll th e blower un it 90° so th at fan blade
microwave.
3
Back of
M icrow ave
Before Rotation After Rotation
Back of
M icrow ave
Back of
M icrow ave
openin gs are facing out th e top of th e
Back of
M icrow ave
AFTER: Fan Blade
Place the blower un it back into the open in g.
Openings Facing Top
CAUTION: Do not pull or stretch the blower
unit wiring. Make sure the wires are not
pinched, and that they are properly secured.
4
with th e top of the un it facin g up.
Place the microwave in its upright position,
EN-13