Manual

PREPARE THE HOOD PREPARE THE HOOD
TEFLON°-COATED BOTTOM COVER
(Held in place with 2 screws)
ELECTRICAL CABLE CLAMP
7 Remove
Teflon<_-coated
bottom cover
from hood. Set
cover and
mounting
aside.
Teflon ® is a registerec
trademark of DuPont.
r-_ Remove
Damper/Duct
Connector
from inside
the hood. Set
connector
aside - with
mounting
screws and
parts bag.
DAMPER/
DUCT
CONNECTOR
[_ Remove
either top or
back wiring
knockout and
install
approved
Electrical
Cable Clamp.
71 Remove Air
Chute - held in
place with one
(1) screw.
NOTE: Be
careful not to
disconnect any
wires.
r_ Remove Baffle
from air chute.
AIR CHUTE
BAFFLE
BAFFLE
\
Non-Ducted installation - Skip to Step 15.
The following
Steps (6 thru
14) are for
DUCTED
INSTALLATION
ONLY.
(3) #8 SCREWS LIGHT
PANEL
[-_ Remove Light Panel - held in place with (3) #8 screws and
(2) #8 screws. Disconnect light assembly wire harness
(white connector).
rq
n
Rotate baffle.
Reinsert baffle into
air chute (as
shown) so that
baffle tabs fit all the
way into slots in air
chute. An audible
"click" will be heard
when fully installed.
This will close off
the air flow through
the non-ducted
slots on top of
hood.
SLOTS
Re-install air chute, re-connect wire
harness, and replace light panel.
NOTE: Be careful not to trap wires
between support fin and light panel.
TABS
SUPPORT FIN