Spec Sheet

INSTALLATION SPECIFICATIONS
Product Shipping Weight (approx.) – 59 Lbs.
Voltage Rating – 120V / 60 Hz / 15 Amps
Connected Load (kW Rating) @ 120 Volts = 1.5 kW (For use on adequately
wired 120V, dedicated circuit having 2-wire service with a separate ground
wire. Appliance must be grounded for safe operation.)
Amps @ 120 Volts = 13 Amps
Always consult local and national electric codes.
Grounded outlet should be located in cabinet above, with hole in base to
route power cord. Carefully follow top template instructions for power cord
clearance when installing beneath smooth, flat cabinets.
Microwave’s exhaust ventilation system is preset to recirculate air inside with
no ducting system required. Exhausting air outside is optional, using either
vertical or horizontal ducting system. (Refer to Ducted Option Specifications
for outside ventilation.)
For safe and proper installation, microwave MUST be mounted to BOTH a
top cabinet AND a wall, and connected to at least one wall stud. Can NOT be
installed in island or peninsula cabinet arrangements.
Cabinet bottom MUST be level to insure proper installation.
Cabinet MUST be capable of supporting a total load of 135 lbs.
When installing beneath smooth, flat cabinets, refer to cabinet template for
detailed power cord clearance instructions.
If cabinet depth (including doors) is deeper than 13", unit MUST be spaced out
from rear wall using adequate materials (supporting 150 lbs.) to allow proper
top vent air exhaust/intake.
Filler blocks recommended for installation when cabinet front hangs below
recessed bottom shelf.
Minimum distance of 30" required from cooking surface to bottom edge of
top cabinet.
Minimum distance of 66" required from floor to top of microwave.
Opening between cabinets MUST be 24" wide and free of obstructions.
Allow 30" minimum clearance for 90° door swing.
DUCTED OPTION SPECIFICATIONS
For outside ventilation.
Exhaust duct adapter will be needed for outside ventilation, to mate with
standard 3-1/4" x 10" rectangular duct. If round duct required, rectangular-to-
round transition adapter will be needed with no less than 6" diameter.
For most efficient airflow exhaust, use a straight run or as few elbows as
possible with a maximum duct length of 3-1/4" x 10" rectangular or 6"
diameter round duct, not to exceed 120 equivalent feet.
For horizontal installation, be sure to allow enough space between wall studs
to accommodate exhaust.
Refer to installation instructions on web for detailed duct preparation and
converting exhaust vent blower system for exterior exhaust ventilation.
Specifications subject to change. Accessories information available on the web at frigidaire.com
Note: For planning purposes only. Always consult local and national electric, gas and plumbing codes.
Refer to Product Installation Guide for detailed installation instructions on the web at frigidaire.com.
USA
10200 David Taylor Drive
Charlotte, NC 28262
1-800-FRIGIDAIRE
frigidaire.com
CANADA
5855 Terry Fox Way
Mississauga, ON L5V 3E4
1-800-265-8352
frigidaire.ca
UMV1422U 08/18
© 2018 Electrolux Home Products, Inc.
†When installing beneath smooth, flat cabinets, refer to cabinet
template for detailed power cord clearance instructions
*Can NOT be installed in island or peninsula cabinet arrangements
**If cabinet depth (including doors) is deeper than 13", unit MUST
be spaced out from rear wall using adequate materials (supporting
150 lbs.) to allow proper top vent air exhaust/intake
23
7
/8"
17"
16
3
/16"
Allow at least 30" clearance
for door depth when open
lower
extrusion
rear
extrusion
Power cord
location
Blower plate allows for vertical
or horizontal ducting
13"
max.**
2"
min.
Backsplash
Rear Wall
24"
min.
66"
min.
from floor
to top of
microwave
Bottom edge of
cabinet MUST be
30"
min. from
cooking surface
Cabinet MUST
be capable of
supporting a total
load of 135 lbs.
(or 150 lbs.**)
30"
min.
16
1
/2"
Microwave MUST
be mounted to
BOTH a top cabinet
AND a wall.*
Locate 120V/60Hz grounded outlet inside upper cabinet
24" Over-the-Range Microwave Oven
Frigidaire Gallery
"
UMV1422U S/W
MICROWAVE
24" OVER-THE-RANGE