Product Manual

Fronius Galvo

Dummy

Explanation of

footnotes

1) The values quoted are default values; the inverter is configured specifically to meet

the needs of the country in question.

2) Depending on the country setup or device-specific settings

(ind. = inductive; cap. = capacitive)

3) PCC = interface to the public grid

4) Maximum current from the inverter to the solar module when an error occurs in the

inverter or when the insulation between the AC and DC side is defective

5) Guaranteed by the electrical configuration of the inverter

6) Current peak when switching on the inverter

7) Depending on the country setup

Applicable stand-

ards and guide-

lines

CE mark

The devices comply with all the requisite and relevant standards and guidelines that form

part of the relevant EU Directive, and are therefore permitted to display the CE mark.

Circuit to prevent stand-alone operation

The inverter has an approved circuit to prevent stand-alone operation.

Grid failure

The standard measurement and safety procedures integrated into the inverter ensure that

in the event of a grid failure, the feed-in of energy is immediately interrupted (e.g. switch-

off by the energy supplier or damage to lines).

Nominal grid voltage 1 ~ NPE 230 V

Grid voltage tolerance +10 / -5 %

Nominal frequency 50 - 60 Hz

Degree of protection IP 65

Dimensions h x w x d 645 x 431 x 204 mm

Weight 16.75 kg