iCommand-Touch Manual

CAP-837
2.7.4.4
"Switching times outputs" screen
Fig. 30: "Switching times outputs" screen
Programming of the time schedule for the digital outputs is done ana
og
ous to the Switching times compressor. There are four schedules
available. These can be allocated to the digital outputs if required. Via
the
can be accessed.
Fig. 31: "Switching times outputs" screen
This channel overview shows that Channel 1 is presently active. Using
the
ming Channel 1 can be accessed.
Fig. 32: "Switching times output" screen
for Channel 1
In this (Fig.
"Display parameters" menu
Overview
Fig. 33: "Display parameters" screen
This menu contains the following submenus:

Dimensions / Offset (
screen

Diagrams (

Texts (

Screensaver (
page

Lock screen (
iCommand
32
"Switching times outputs" screen
Programming of the time schedule for the digital outputs is done ana
ous to the Switching times compressor. There are four schedules
available. These can be allocated to the digital outputs if required. Via
the
"Timer Scheme 1" (Fig. 30
/1) the channel overview for scheme 1
can be accessed.
This channel overview shows that Channel 1 is presently active. Using
the
"Channel 1 active" (Fig. 31
/1) button the submenu for progra
ming Channel 1 can be accessed.
In this (Fig.
32
) the scheme of Channel 1 can be programmed.
This menu contains the following submenus:
Dimensions / Offset (
 Chapter 2.7.4.5 ‘
"Dimensions / Offset"
screen
’ on page 39)
Diagrams (
 Chapter 2.7.4.6 ‘"Diagrams" screen
’ on page
Texts (
 Chapter 2.7.4.7 ‘"Texts" screen’ on page
41
Screensaver (
 Chapter 2.7.4.8 ‘
"Screensaver" screen
page
436)
Lock screen (
 Chapter 2.7.4.9 ‘
"Lock Display" screen
iCommand – Touch
iCommand
- Touch
Programming of the time schedule for the digital outputs is done ana
l-
ous to the Switching times compressor. There are four schedules
available. These can be allocated to the digital outputs if required. Via
/1) the channel overview for scheme 1
This channel overview shows that Channel 1 is presently active. Using
/1) button the submenu for progra
m-
) the scheme of Channel 1 can be programmed.
"Dimensions / Offset"
’ on page
40)
41
)
"Screensaver" screen
’ on
"Lock Display" screen
’ on page 43)