iCommand-Touch Manual

CAP-837
Parameter
Value setting/Initial setting/Remarks
RS485 protocol
Specifies the protocol type on the RS485 networking
interface.
Setting range:
MODBUS / Standard
RS485 address
Specifies the participants address in the RS485
network.
Setting range: 0 –
27
Initial setting: 1
RS485 baud rate
Setting range:
4800 / 9600 / 19200 / 38400 / 57600 / 115200
Initial setting:
19200
RS485 frame
Specifies the protocol frame when networking via
Modbus (data bits/parity/stop bits).
Setting range:
8/NONE/1, 8/NONE/2, 8/EVEN/1, 8/ODD/1
Initial setting: 8/NONE/1
RS485 access
Specifies the authority for
interface. Depending on setting, either no parameter
or only parameter with the respective code level can
be changed. Depending on the entered code, not all
settings
are available.
Setting range: Read only, Read/write customer,
Read/w
rite service, Read/write factory
Initial setting: Read/write service
iCommand
38
Value setting/Initial setting/Remarks
Compressor
type
Specifies the protocol type on the RS485 networking
MODBUS / Standard
All
Specifies the participants address in the RS485
27
All
4800 / 9600 / 19200 / 38400 / 57600 / 115200
19200
All
Specifies the protocol frame when networking via
Modbus (data bits/parity/stop bits).
8/NONE/1, 8/NONE/2, 8/EVEN/1, 8/ODD/1
Initial setting: 8/NONE/1
All
Specifies the authority for
changes via the RS485
interface. Depending on setting, either no parameter
or only parameter with the respective code level can
be changed. Depending on the entered code, not all
are available.
Setting range: Read only, Read/write customer,
rite service, Read/write factory
Initial setting: Read/write service
All
iCommand – Touch
iCommand
- Touch
Compressor
State
Display
Display
Display
Display
Display