iCommand-Touch Manual

CAP-837
Fault message
Remarks
E078:
Line pressure high
Network pressure too high. The pressure has exceeded
the set upper limit.
E079:
System pressure conf.
The system pressure switch digital input has not
opened after 35 s in on
E095:
I/O-Module (Add.4)
The accessory module on address 4 (Type MK200
8E4RA) does not respond. This monitoring is only a
tive, if this module has
E096:
I/O-Module (Add.5)
The accessory module on address 5 (Type MK200
8E4RA) does not respond. This monitoring is only a
tive, if this module has been selected.
E108: Dew point dryer
The dew point exceeded the permissible
while motor is running (if set in menu). Only if heating is
not active or not available.
E109: Dew point low
The dew point cut short of the permissible minimum
while motor is running (if set in menu). Only if heating is
not active or not avail
E110: Ext. Err. 1
The digital input programmed on "External fault 1" was
triggered.
E111: Ext. Err. 2
The digital input programmed on "External fault 2" was
triggered.
E112: Ext. Err. 3
The digital input programmed on "External fault
triggered.
E113: Ext. Err. 4
The digital input programmed on "External fault 4" was
triggered.
iCommand
55
Remarks
Network pressure too high. The pressure has exceeded
the set upper limit.
The system pressure switch digital input has not
opened after 35 s in on
-load operation.
The accessory module on address 4 (Type MK200
8E4RA) does not respond. This monitoring is only a
c-
tive, if this module has
been selected.
The accessory module on address 5 (Type MK200
8E4RA) does not respond. This monitoring is only a
c-
tive, if this module has been selected.
The dew point exceeded the permissible
maximum
while motor is running (if set in menu). Only if heating is
not active or not available.
The dew point cut short of the permissible minimum
while motor is running (if set in menu). Only if heating is
not active or not avail
able.
The digital input programmed on "External fault 1" was
triggered.
The digital input programmed on "External fault 2" was
triggered.
The digital input programmed on "External fault
3" was
triggered.
The digital input programmed on "External fault 4" was
triggered.
iCommand – Touch
iCommand
- Touch
Compressor type
All
All
All
All
All
All
All
All
All
All