iCommand Manual

CAP-836
2.7.8
Set switch on/off pressure: Code 0011
iCommand
25
Set switch on/off pressure: Code 0011
By inputting the code 0011, it is possible to set the switch
off pressure. The switch-
on pressure specifies the pressure at which the
switched-on compressor w
ill begin automatically with the compression.
The switch-
off pressure specifies the pressure at which the compressor
will be switched off automatically. However, both functions are only active
in automatic operation.
1.
Press and hold for three seconds.

The code input menu appears on the display.
2.
Press .

A 1 appears on the display.
3.
Press .
4.
Set the code 0011 with the keys.
5.
To confirm the selected code, press .
6.
Press .

The submenu for setting the switch-
on pressure appears on the
display.
7.
The adjustment range for the switch
with switch-
off pressure set at the factory, between
psi and 155 psi.
Set the desired switch-on pressure with the
8.
To confirm the setting, press the key.

The set value was saved and the submenu for setting the
switch-
off pressure appears on the display.
9.
The adjustment range for the switch-
off pressure is, with
switch-
on pressure set at the factory, between
175 psi. The upper limit for the switch
-
to the maximum pressure.
Set the desired switch-off pressure with the
10.
To confirm the setting, press the key.

The set value is saved and the code input
the display again.
11.
Press
again to go back to the basic display.
iCommand
- Basic
By inputting the code 0011, it is possible to set the switch
-on and switch-
on pressure specifies the pressure at which the
ill begin automatically with the compression.
off pressure specifies the pressure at which the compressor
will be switched off automatically. However, both functions are only active
The code input menu appears on the display.
on pressure appears on the
The adjustment range for the switch
-on pressure is,
off pressure set at the factory, between
80
keys.
The set value was saved and the submenu for setting the
off pressure appears on the display.
off pressure is, with
on pressure set at the factory, between
100 psi and
-
off pressure is equal
keys.
The set value is saved and the code input
menu appears on
again to go back to the basic display.