Instructions / Assembly

Lighting Instruction Manual
Warning: Before Lighting, please make sure that the control knob
is in the off position and the regulator assembly is in good
condition.
Control Knob. IMPORTANT Do not leave items on or against the
barbecue. Keep flammable product and sprays away.
For outdoor use only.
SHUT DOWN INSTRUCTIONS:
1.Turn burner control knob to the OFF position.
2.Turn gas supply OFF.
3.The gas supply must be turned off when appliance is not in use.
LIGHTING INSTRUCTIONS
1. Read instructions before lighting.
2. Open lid during lighting and make sure burner is in the OFF
position. Make sure the burner kit is properly fixed with respect
to the orifices. Control knob must be in the “OFF” position.
3. Turn on tank valve or gas supply and do the leak testing as the
procedures shown in the manual.
4. Push and turn the control knob to “START/ALLUMER” for the
burner you are trying to light. Push the igniter button. The
burner should light. If it does not, repeat up to three times.
5. If ignition does not occur within 5 seconds, turn the burner
control knob “OFF”, wait 5 minutes for any excess gas to
dissipate. Repeat step 1 through 5.
6. After burners are lit the dial can be adjusted to regulate the
heat output on each burner.
MATCH LIGHTING:
1. Repeat step 1 through 3 in the previous lighting instructions;
put a match into the lighting rod, light the match and place it
through the hole of flame tamer to the burner tube; Push
control knob and turn slowly to the “START/ALLUMER” position.
2. If ignition does not occur within 5 seconds, turn the burner
control off, wait 5 minutes for any excess gas to dissipate.
3. After burners are lit the dial can be adjusted to regulate the
heat output on each burner.
Important: Always use the lighting rod (include) when lighting
burners with a match.