Instructions / Assembly

Grill Burner Exterior Cleaning

Orifice Cleaning:

With the burner removed, remove the orifice and shine a flashlight through the opening to ensure there is

no blockage. Use a needle to clear any debris. Be extremely careful not to enlarge the hole or break off the

needle. This should be done any time an obstruction is detected.

IMPORTANT:

Installation after cleaning:

After the cleaning, properly locate and re-attach the burner kit with respect to the orifices. Adjust the

igniter tip located near the burner edge.

WARNING:

DO NOT REMOVE BURNER OR PERFORM CLEANING WHILE GRILL IS STILL HOT.

1. Clean the exterior of the burner with a wire brush.

2. Clean stubborn scale with a metal scraper.

3. Clear any clogged ports with a straightened paper clip.

4. Never use a wooden toothpick as it may break off and

clog the port.

5. Shake out any debris.

6. Use a flashlight to inspect the burner inlet to ensure it is

not blocked.

7. If obstructions can be seen, use a metal wire coat

hanger that has been straightened out.

8. Check and clean burner /venture tubes for insects and

insect nests. A clogged tube can lead to a fire beneath

the grill.

*Please clean every 6 months and any time an obstruction

is noticed.

122.9

304HL T=1.0mm

304HL T=0.6mm

304HL T=1.5mm

304/2B T=1.0mm

304/2B T=0.8mm

304HL T=2MM

上盖支撑右