User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
Setup Mode
USING SETUP MODE
User's Manual 5-13
Quick
Reference
Introduc-
tion
Setting Up
Paper
Handling
Printing
Setup Mode
Table 5.2 Required Options (Cont.)
HARDWRE FORMAT If you have a serial interface, the serial
BAUD-RT interface options selected on the printer
PROTOCL must be the same as the settings you
DSR selected using your software or your
DUPLEX computer operating system. If the settings
CTS are not the same, the printer will not
CD print or will print garbage.
See the section Changing Hardware
Options later in this chapter.
ADJUST None If you are not using software to specify
the top margin of the page, use the
printer’s default top-of-form setting,
1 inch (25.4 mm) from the top of the
paper. If you are using software to
specify the top margin of the page,
change the default setting to 1/6 inch
(4.2 mm).
See the section Changing Print Position
Adjustment Options later in this
chapter.
CONFIG None If you are using paper that is dark-
colored or preprinted with dark colors,
you may need to disable the AREA
OVER detection function.
See the section Changing Configuration
Options later in this chapter.
Function Item Option