User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
USING SETUP MODE
User's Manual5-24
MENU1 and
MENU2 Items
Table 5.3 MENU1 and MENU2 Items and Options (Cont.)
NOTES:
• Underlined options are the factory defaults.
• Asterisks identify items and options that differ for the IBM XL24E and Epson
ESC/P2 emulations. The notes are defined at the end of the table.
<CHR-SET> SET 1 IBM character set 1
SET 2 IBM character set 2
If a downloaded (soft) font is used, the
character set for that font overrides the
<CHR-SET> setting.
(*3)
ITALIC Italic characters are available.
GRAPHIC Graphics characters (ruled lines) are
available.
<PRF-SKP> For continuous forms, this option
specifies whether an inch is skipped
around the perforation. If you are not
using software to specify a bottom
margin, select SKIP when using thicker,
multipart forms.
SKIP One inch is skipped around the perfora-
tion.
NO-SKIP The perforation is not skipped. Printing
continues in the bottom margin of the
page.
<WIDTH>
13.6 IN 13.6-inch page width
(*5) 11.4 IN 11.4-inch page width
11.0 IN 11-inch page width
8.0 IN 8-inch page width
<ZEROFNT> Specifies whether to print the number
(*2) zero with a slash. This is useful to
distinguish the capital letter “O”
from the number “0”.
Invalid for some soft fonts.
NO-SLSH 0
SLASH 0/
Options Description