User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
Setup Mode
USING SETUP MODE
User's Manual 5-33
Quick
Reference
Introduc-
tion
Setting Up
Paper
Handling
Printing
Setup Mode
Table 5.4 HARDWRE Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
HARDWRE Options Description
Items
<BAUD-RT> 150 The baud rate is in bps (bits per
300 second). Select the same baud rate as
600 used by your computer or modem.
1200
2400
4800
9600
19200
<PROTOCL> Indicates data transmission protocol.
XON/XOF The DC1 and DC3 codes are used.
DTR
The Data Terminal Ready signal is used.
REV-CHL The Reverse Channel signal is used.
<DSR> IGNORE DSR is ignored by the printer.
DETECT DSR is detected by the printer.
<DUPLEX>
FULL Simultaneous data transmission occurs in
opposite directions.
HALF Data transmission occurs in either
direction, but not simultaneously.
<CTS> IGNORE CTS is ignored by the printer.
DETECT CTS is detected by the printer.
<CD> IGNORE CD is ignored by the printer.
DETECT CD is detected by the printer.
<==END==>
Indicates the end of the HARDWRE
item list. Press the MENU button to print the
first item, which is <PPR-OUT>. Press the
TEAR OFF button to print the previous item.
Press the ONLINE button to reprint the
<<FUNCTION>> menu.