User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
Setup Mode
USING SETUP MODE
User's Manual 5-35
Quick
Reference
Introduc-
tion
Setting Up
Paper
Handling
Printing
Setup Mode
6. Do either of the following:
• Select another function, or
• Exit setup mode, saving your changes.
For details on other functions, see the other sections in this chapter.
To exit setup mode and save your changes, make sure that the red
cursor is positioned under SAVE & END, then press the MENU
button or the TEAR OFF button.
When you print using ruled paper, you often want to adjust the print position
so that the print sits properly on the ruled lines. The ADJUST function
allows you to:
• Set top-of-form position
• Fine-tune top-of-form position
• Fine-tune left print start column (left margin)
• Adjust for accumlative line spacing error in a page
The first three items are provided separately for cut single sheets and
continuous forms. The last item is available for single sheets only.
The top edge of your paper is the physical top of the page. The logical top
of the page, as “understood” by the printer when loading paper, is called the
top-of-form. Printing starts at this position. Note that printing actually starts
at the position obtained by adding the following:
• Top-of-form, default = 1.8/6 inch (7.6mm)
• Top margin specified by your software
• Printer TOP-MRG (top margin setting), default = 1 line
Table 5.5 describes the ADJUT items and options. Items are listed in the
order they are printed. The procedure for changing top-of-form is described
after Table 5.5.
CHANGING PRINT
POSITION ADJUSTMENT
OPTIONS