User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
Setup Mode
USING SETUP MODE
User's Manual 5-37
Quick
Reference
Introduc-
tion
Setting Up
Paper
Handling
Printing
Setup Mode
Table 5.5 ADJUST Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
ADJUST
Items
<CNT-LFT> Fine-tunes the left print start
position for continuous forms.
–10/90, ...,
0/90, Moves the position left or
..., 10/90 right in increments of 1/90
inch (0.28 mm).
<CUT-LFT> Fine-tunes the left print start
position for single sheets.
–10/90, ...,
0/90, Moves the position left or
..., 10/90 right in increments of
1/90 inch (0.28 mm).
<CUT-ADJ> Compensates the line spacing
pitch on the basis of the
spacing error accumulated for
feeding single sheets by10
inches.
Decreases or increases in
increments of 1/360 inch in
total.
<CNT-ADJ> Compensates for the forms
feed error accumulated
through feeding of continuous
forms.
<CNTADJL> Compensates for the forms
feed error accumulated
through feeding of continuous
forms. (Last page)
*1:When printing graphics, selecting "GRAPHIC" may result in the
printing of clearer graphics.
Options Description
–21/360, –14/360,
–7/360,
0/360,
7/360, 14/360, 21/360,
GRAPHIC (*1)
–28/360, –21/360,
–14/360, –7/360,
0/360,
7/360, 14/360, 21/360,
28/360, GRAPHIC (*1)
–21/360, –14/360,
–7/360,
0/360,
7/360, 14/360, 21/360,
GRAPHIC (*1)