User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
USING SETUP MODE
User's Manual5-4
Select Function SAVE & END Exits setup mode and saves any changes made
while in setup mode.
MENU1 and Assigns print features to MENU1 and
MENU2 MENU2 on the printer control panel.
HARDWRE Changes the printer hardware options.
ADJUST Changes the print position adjustment options.
CONFIG Changes the configuration options.
The initial printout contains a header, help menu, and <<FUNCTION>>
menu. The header tells you that the printer is offline and in setup mode. The
help menu provides a quick summary of how to use setup mode. The
<<FUNCTION>> menu lists all of the functions available to you in setup
mode. Note that the red cursor on the plastic print guide is initially positioned
below the SAVE & END function.
Setup mode can also be entered by turning off the printer, then turning the
printer back on while pressing the TEAR OFF and ONLINE buttons simulta-
neously until the printer beeps.
When you enter setup mode, the following <<FUNCTION>> menu is printed:
OVERVIEW OF SETUP
MODE
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
Table 5.1 summarizes the purpose of each function.
Table 5.1 Setup Mode Functions
Type Function Purpose