User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
USING SETUP MODE
User's Manual5-42
Table 5.6 CONFIG Items and Options (Cont.)
NOTE: Underlined options are the factory defaults.
CONFIG Items Options Description
<TEAR-EN> In some application programs, data
(continued) transfer may stop temporarily due
to internal processing. This setting can
avoid an undesired tearoff feed by
waiting for up to six seconds each time
data transfer stops.
<CUTLOAD> Single sheet autoloading.
AUTO Single sheet paper is automatically
loaded a certain time after you set
the paper.
BUTTON Single sheet paper can be loaded by
pressing the LOAD button.
The following <LOADTIM> item is printed when CUTLOAD:AUTO is
specified for the <CUTLOAD> item.
<LOADTIM> Autoload start time.
0.5,
1.0, Autoloading starts when this
1.5, 2.0 amount of time passes after you set
2.5, 3.0SEC single sheet paper.
<DECODE> Command decode timing.
DIRECT The printer decodes certain commands
immediately after receiving data.
Example:
ESC SUB I, ESC CR P (DPL24C+)
ESC Q # (IBM XL24E)
QUEUED
The printer decodes commands after
storing all data (including commands)
in the input buffer. This speeds data
reception because the printer does not
require decoding time during data
reception.