User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
Setup Mode
USING SETUP MODE
User's Manual 5-47
Quick
Reference
Introduc-
tion
Setting Up
Paper
Handling
Printing
Setup Mode
2. Select the CONFIG function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under CONFIG. Press the MENU button to select the
CONFIG function and print the following <TEAROFF> options:
<TEAROFF> MANUAL AUTO
3. Select an option.
Press the LOAD button or the LF/FF button to move the cursor to
either MANUAL or AUTO. Press the MENU button to select the
option and print the <TEARPOS> item. If other items must be
specified, do so now. Otherwise, go to step 4.
4. Exit the CONFIG function.
Press the ONLINE button to exit the CONFIG function and reprint
the <<FUNCTION>> menu.
5. Do either of the following:
• Select another function, or
• Exit setup mode, saving your changes.
For details on other functions, see the other sections in this chapter.
To exit setup mode and save your changes, make sure that the red
cursor is positioned under SAVE & END, then press the MENU
button or the TEAR OFF button.
.
Procedure
To change the printer configuration options, make sure that continuous
forms paper is loaded and then proceed as follows:
1. Enter setup mode.
Press the TEAR OFF button and the ONLINE button simultaneously
until the printer beeps. Wait for the printer to stop printing and
check that the following <<FUNCTION>> menu is printed:
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT