User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
USING SETUP MODE
User's Manual5-48
<<FUNCTION>>
SAVE&END MENU1 MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
2. Select the SAVE & END function.
Make sure that the red cursor is positioned under SAVE & END.
Press the MENU button or the TEAR OFF button to select SAVE &
END. The printer exits setup mode and returns online (the ONLINE
indicator lights green). Any changes you made while in setup mode
are saved.
This section describes how to exit the setup mode save any changes you
made:
To exit setup mode immediately, select the SAVE & END function.
Any settings changed while in setup mode are saved as the new power-on
defaults for the printer. The new defaults remain active until you change them
again.
NOTE
The only way to exit setup mode without saving your changes is to turn off
the printer. When you turn the printer back on, the previous default
settings are used.
Procedure
To exit setup mode and save your changes using SAVE & END, proceed as
follows:
1. Print the <<FUNCTION>> menu.
The <<FUNCTION>> menu should be the last printed line on the
page. If the menu is not printed, press the ONLINE button to print the
menu. If you are using the SELF-TST or HEX-DUMP function, press
the LF/FF button instead of the ONLINE button to print the menu.
The <<FUNCTION>> menu is shown below.
EXITING AND SAVING