User's Manual
Table Of Contents
- CHAPTER5 Using Setup Mode
- How to use this chapter
- Entering Setup Mode
- Overview of Setup Mode
- Printing a List of Selected Options
- Deciding Which Options to Change
- Changing MENU1 and MENU2 Options
- Changing Hardware Options
- Changing Print Position Adjustment Options
- Changing Configuration Options
- Exiting and Saving
- Resetting Defaults
- Using the Diagnostic Functions
- Setup Mode Reference
- Online Setup MODE
- CHAPTER6 Maintenaice
- CHAPTER7 Trouble-shooting
- CHAPTER8 Installing options
USING SETUP MODE
User's Manual5-56
2. Select the V-ALMNT function.
Repeatedly press the LOAD button or the LF/FF button to position
the red cursor under V-ALMNT, then press the MENU button or the
TEAR OFF button to select the V-ALMNT function. The printer
prints the help menu then starts printing rows of parallel bars using
letter quality speed.
3. Adjust the vertical print alignment at letter quality speed.
Examine the parallel bars. If the bars are aligned (not jagged), go to
step 4. If the bars are offset to the left, repeatedly press the LOAD
button until the bars are aligned. If the bars are offset to the right,
repeatedly press the LF/FF button until the bars are aligned. (In the
following figure, the first line is assumed to be printed from left to
right.)
Bars offset to the left Bars offset to the right
4. Adjust the vertical print alignment at correspondence speed.
Press the TEAR OFF button to switch from letter speed to corre-
spondence speed.
Examine the parallel bars and adjust the vertical print alignment as
described step 3.
5. Adjust the vertical print alignment at draft speed.
Press the TEAR OFF button to switch from correspondence speed to
draft speed.
Examine the parallel bars and adjust the vertical print alignment as
described step 3.